Vase measurements: how to measure and choose a vase

The key vase measurements are its height, opening diameter and widest body diameter; measure usable depth and base width too when checking whether flowers will fit securely. Use centimetres or inches consistently, and distinguish external dimensions from internal space. For a starting proportion, stems measured from their cut ends to the tops of the flowers can be about 1.5–2 times the vase height, adjusted for weight and shape.
The opening determines how tightly stems sit together, while the depth determines how much stem the vase can support below the rim. Two vases with identical advertised dimensions can hold a bouquet very differently if one has a narrow neck or thick walls. Before choosing from the bouquets catalogue, a few measurements of the recipient’s existing vase can help you judge which flower shapes will be practical at home.
1. How to take accurate vase measurements
Put the empty vase on a level surface. Measure its external height vertically from the tabletop to the highest point of the rim, rather than following a curved side. For an uneven or sloping rim, record both the lowest and highest points. This gives you a reliable figure for shelf clearance and shows approximately where the stems will begin to emerge.
Measure straight across the centre of a round opening, from inside edge to inside edge. This is the usable opening diameter, which may be smaller than the outer rim measurement shown in a product listing. For an oval or rectangular opening, record both length and width. If the neck narrows below the rim, measure that restriction too: a flared lip can conceal a much tighter passage.
Next, measure the widest outside part of the body and the width of the base that actually rests on the table. Check internal depth with a clean ruler, lowering it gently to avoid damaging the vase. Write the results with labels, for example: height 25 cm, inner opening 10 cm, body width 16 cm. An unexplained sequence such as 25 × 16 × 10 can be ambiguous.
2. Match vase height to the bouquet’s stem length
Treat the 1.5–2-times-height proportion as a visual starting point rather than a care rule. In a 25 cm vase, flowers measuring roughly 38–50 cm from the cut ends to their highest point may look balanced. The vase and stems overlap, so do not add their full lengths together when calculating the finished display height. Measure the arrangement from the tabletop once the stems are in place.
Weight changes the decision. A bouquet with large, heavy flower heads may need a taller supporting body and a heavier base than a light, airy arrangement of the same length. Long stems leaning sharply over a low rim can pull the display off balance. Before adding flowers, check that the empty vase sits flat; after arranging, check again for rocking or a strong lean.
Avoid cutting every stem to a calculated length before trying the bouquet in its vase. Hold it alongside the vessel to estimate the first cut, then shorten gradually with a clean, sharp tool. Keep enough length for the intended shape and water access. A low dining-table arrangement needs a different silhouette from a bouquet standing on an open console, even when both use the same flowers.
Bouquets we can deliver
3. Choose the opening for the stem bundle and arrangement
To assess the opening, gather the stems loosely at the point where they would pass through the neck. Measure across that bundle without squeezing it into a rigid cylinder. Allow room to place and remove the stems without scraping them. There is no dependable opening size based on flower count alone: ten slender stems and ten thick stems can occupy very different amounts of space.
A narrow neck supports a compact outline and can hold a few stems upright, but an opening that grips the whole bouquet makes arranging and cleaning awkward. A wide opening lets stems spread and creates a fuller outline, although a small bunch may fall towards the edges. Match the opening to the shape you want, rather than assuming the widest vase is always the most accommodating.
Consider the entire path into the vessel. A bulbous vase may offer plenty of water space but have a neck too tight for a mixed bouquet. A straight cylinder is easier to assess because its width stays consistent. For delicate or branching stems, check that you can insert them individually without forcing side shoots through a narrow throat; remove only foliage that needs to come off for the arrangement.
4. Check usable depth, water space and cleaning access
External size does not tell you water capacity. Thick glass, a raised inner bottom or a tapered body can reduce the space available beneath the flowers. If capacity matters, use a measuring jug to fill the empty vase to a marked, practical waterline and record the amount. Once stems are added, the water rises, so leave space below the rim and check the level again.
Choose a water level appropriate to the flowers and follow any supplied care instructions. Remove leaves that would sit below that level, and make sure every cut stem end reaches the water, including shorter stems hidden inside a mixed bouquet. Check the level daily: a tall vase can look sufficiently full from the outside while some ends are no longer submerged.
A vase should also be easy to clean between bouquets. Inspect the neck and bottom for places where residue may collect, and consider whether a suitable brush can reach them. Wash and rinse thoroughly before arranging fresh flowers; simply topping up old water leaves accumulated debris behind. For rose-specific handling after choosing a vase, see our guide to rose vase life.
5. Measure the place where the flowers will stand
Measure the usable surface, not just the vase footprint. The widest flowers and leaves may extend well beyond the body of the vessel, especially in a spreading arrangement. Leave room for nearby objects and normal movement around the table. On a shelf, check the total display height and the space needed to lift the vase out without crushing the flowers against the shelf above.
For a dining table, sit down and check the arrangement at eye level before settling on its height. A display can fit comfortably under a light fitting yet still block conversation across the table. On a narrow console or bedside table, a stable base and a restrained spread may matter more than a dramatic outline. Keep the vase away from edges where a sleeve or bag could catch it.
Location also affects flower care. Avoid direct sun, heaters and strong draughts where possible, and keep the arrangement away from ripening fruit. Do not choose a dark, awkward corner solely because a tall vase fits there: you still need access to check the water and remove fading material. Our guide to where to put a bouquet helps you assess the space before arranging.
6. Use vase measurements when sending flowers to Russia
If you are ordering from abroad, ask the recipient for the vase height and inner opening diameter when that would not spoil the surprise. Otherwise, describe the available space and any known preferences. Contact a manager on WhatsApp for help choosing a bouquet, agreeing the address, delivery time and card text, and arranging a photo of the bouquet before delivery. Share measurements with units and clearly label each figure.
We deliver flowers across Russia. City delivery costs 500 RUB; an operator confirms the price for remote districts and suburbs when confirming the order. Express delivery in large cities is available 1–2 hours after order confirmation. You can also arrange an exact time within ±30 minutes, choose a 09–12, 12–15, 15–18 or 18–21 window, or pre-order 1–30 days ahead. Use the recipient’s local time when agreeing details.
Delivery is anonymous by default: the courier does not name the sender, and a card with your text is free. Add your name to the message if you want the recipient to know who sent the flowers. The courier calls about 15 minutes before arrival. Online checkout uses CloudPayments; check the payment options displayed there, as acceptance of every foreign card is not guaranteed. Read the delivery and payment details when planning your order.
Frequently asked questions
What order are vase measurements written in?
There is no universal order across product listings, so look for labels rather than assuming what each number means. Record height, opening diameter and body width separately, and specify whether each width is internal or external.
How do I convert vase measurements from inches to centimetres?
Multiply inches by 2.54 to get centimetres, or divide centimetres by 2.54 to get inches. For example, a 10-inch vase is 25.4 cm tall; keep the same unit throughout your notes to avoid mistakes.
How tall should flowers be compared with their vase?
A useful starting point is a cut-end-to-flower-top length of about 1.5–2 times the vase height. Adjust for the weight of the flower heads, the support provided by the neck and the space where the display will stand.
Can I choose a vase by its water capacity alone?
Capacity tells you how much water a vessel holds at a given fill level, but it does not tell you whether the stems will fit through the neck. Check the inner opening, usable depth and stability as well.
What should I do if the bouquet is too large for my vase?
Use a larger, stable vessel or divide the flowers between two clean vases, keeping every cut end in water. Avoid forcing a thick bundle through a narrow opening; shorten stems gradually only if a lower arrangement suits the flowers and available support.
Ready to send flowers?
Pick the city, choose the bouquet, and a local florist takes it from there.
Choose a city →